Ducted Air Conditioning Installation in Melbourne — Get a Free Quote
Celik Group Air Conditioning, in business since 2004, provides ducted air conditioning in Melbourne, giving houses whole-home heating and cooling from one central ducted system that stays mostly out of sight. We install refrigerated reverse cycle air conditioning, ducted evaporative cooling and gas ducted heating, and if you feel uncertain about the technology choice, we help you pick the right one before anything is quoted.
Refrigerated, Evaporative and Gas Ducted Systems
Brivis, Braemar, Breezair, Actron Air and Daikin
Free Suitability Check and Itemised Quote

Get a fast quote
From new systems to replacing old units, our team handles it all.
20+ Years Experience
Fully Licensed & Insured
1,000+ AC Installations
Interest-Free Payment Options
ARCtick Licensed
Cm3 Accredited
How We Install Ducted Systems in Melbourne
A ducted system relies on discreet indoor unit placement, hiding an indoor bulkhead unit or gas heater unit in the roof cavity, and pushes heated or cooled air through supply air ducts to ceiling vents, floor vents or duct registers in each room. Compared with several split systems, you get one controller, one outdoor unit and no wall-mounted units in every room.
Every ducted system installation in Melbourne kicks off with a property suitability assessment. We check roof cavity access constraints, subfloor ducting access where applicable, measure each room, work out capacity sizing and design the ducting layout with flexible ducting or rigid ducting to suit the ceiling ducting space. Where access is tight, or a bulkhead air conditioning unit would suit better, the feasibility check tells you before you commit.

Ducted Systems Fitted to Melbourne Housing, From Period Homes to New Estates
Choosing a ducted air conditioning installer in Melbourne starts with the house itself. Brick veneer and weatherboard homes in established suburbs often have gas ducting worth testing; period homes spread across the inner and middle suburbs can have tight roof access; and new-build estates have clear ceiling space ready for zoned layouts. Celik Group Air Conditioning puts an itemised quote and plain warranty terms in writing, so weighing up installers is straightforward. We manage all kinds of commercial and residential work so every property receives the best service,
Our ducted installation work in Melbourne reaches established homes in Box Hill, Blackburn and Balwyn, character homes in Camberwell and Canterbury, two-storey houses in Bulleen and Bundoora, growth-corridor estates in Wollert, Craigieburn and Epping, and renovated and extended houses in Burwood, Brighton, Broadmeadows and Campbellfield.
Ducted System Offers in Melbourne
- No-cost suitability check, ducting layout advice and an itemised ducted quote
- Swapping an old gas ducted heater for electric? We lodge the VEU rebate claim.
- Spread the cost of refrigerated or evaporative ducted systems with Zip or HummLoan.
- Our refrigeration mechanics and mechanical plumbers sign off each ducted install with a compliance certificate.
- Pre-summer and pre-winter maintenance agreements that keep Melbourne ducted systems running well
- Package price when a full ducted system and zone control are fitted at once
Matching the Ducted Layout to Your House
Existing Gas Ducting – old runs are tested for condition and airflow before a new unit goes on them.
New Build – ducts, dampers and the controller go in during construction, so nothing is retrofitted later.
Extension – new branch ducts reach the added rooms and tie back into the main unit.
Two Storeys – each floor gets its own zone, so bedrooms and living areas run separately.
Don’t take our word
See What Customers Talk About US
Clients leave five-star reviews for our ducted work, often mentioning neat vent placement, easy-to-read quotes and a crew that left the ceiling space clean.
VEU Rebate Deals





We also offer AirTouch Controllers
AirTouch 2 adds a wall-mounted touchscreen and free mobile app to your ducted system, so every zone gets its own airflow control. Browse our installed pricing from Daikin, Mitsubishi Electric, Panasonic and Rinnai.


12.5kw to 20kw
from $10,250
Includes the VEU rebate, GST and the replacement of the old ducts and grills.

12.5kw to 20kw
from $10,250
Includes the VEU rebate, GST and the replacement of the old ducts and grills.

12.5kw to 18kw
from $11,350
Includes the VEU rebate, GST and the replacement of the old ducts and grills.

13.0kw to 18kw
from $9,750
Includes the VEU rebate, GST and the replacement of the old ducts and grills.
The listed prices are subject to a site visit. If there are any variations or adjustments we will quote this accordingly.
Heating & Air Conditioning Services in Melbourne

Reverse Cycle

Split Systems

VRV

Evaporative Cooling

Air Conditioning Service & Repairs

Heating
Get in Touch
Reach out to Celik Group Air Conditioning, and we will arrange a no-cost suitability check and itemised quote on ducted air conditioning installation in Melbourne, including a technology comparison, ducting layout and a booked installation date.
Why Homeowners Pick Us as Their Ducted Air Conditioning Installer in Melbourne
Each ducted heating and cooling installation in Melbourne is handled by Celik Group Air Conditioning’s own licensed technicians, with no subcontractors, meeting the licensed technician requirement across all ducted technologies. Refrigerant and reverse cycle connections are made under an ARCtick refrigerant licence, gas ducted heating work meets Victorian gas fitting licence requirements, and the electrical isolator switch and dedicated circuit breaker are wired to the AS/NZS 3000 wiring rules. Installation follows manufacturer installation guidelines, and before handover the system is commissioned and the warranty registered, with a compliance certificate issued.






Duct Air Conditioner Installation in Melbourne by a Team Trusted Since 2004
Choosing between refrigerated and evaporative for your ducted cooling installation in Melbourne comes down to budget, humidity and running cost. A refrigerated ducted system uses an outdoor condenser unit and refrigerant line set and cools reliably on humid days. An evaporative ducted system pulls air through wet evaporative cooling pads, costs less to run and works best in dry weather with some windows open. We compare both, along with Braemar, Brivis, Breezair, Rinnai, Actron Air, Mitsubishi Electric and Daikin equipment.
The same licensed team also installs VRV systems for commercial buildings, AirTouch 5 controllers, zone management systems for smarter control, and heating upgrades, as part of our wider air conditioning range. Celik Group Air Conditioning also runs a repair service for evaporative cooling, Mitsubishi air conditioning, reverse cycle air conditioning, Daikin air conditioning, ducted heating and split systems.

Why Our Ducted Installations Hold Up for Years
Celik Group Air Conditioning is Daikin authorised, VEU registered, ARCtick licensed and Cm3 accredited, and brings those credentials to every job involving ducted air conditioning in Melbourne.
All Three Ducted Technologies
Whether you want cooling only or a ducted heating and cooling installation in Melbourne, our own crew installs refrigerated, evaporative and gas systems, so advice is never tied to one product.
Sizing Done Properly
Every ducted system installation in Melbourne is sized from room-by-room heat load figures that account for north-facing room heat gain and open-plan living areas, so each vent delivers even airflow.
Quotes You Can Compare
Your installation quote lists equipment, ductwork, labour and commissioning on separate lines, which makes comparing us with other installers simple.
Minimal Ceiling Disruption
Duct routes are planned around existing roof access, keeping cut-ins small and the finished ceiling clean with only vents on show.
Consolidation Made Easy
Replacing several separate split systems with one ducted system means one controller, one outdoor unit and fewer appliances to service.
Care After Handover
For ducted heating and cooling in Melbourne, we register the warranty, book the first annual service and hand over ongoing maintenance to the team that installed it.
Zoned Ducted Heating and Cooling in Melbourne, Room by Room
A zoned ducted system splits the house into areas, each run by a motorised zone damper and a zone controller panel. Bedrooms can stay on overnight while the living area is off, and a two-storey home can heat upstairs and downstairs on separate schedules. A single-zone ducted installation in Melbourne still suits smaller or open-plan homes where every room needs the same output.
Zoning is easiest to add during a new ducted air conditioner installation in Melbourne, but it can also be retrofitted to an existing single-zone system. A Wi-Fi thermostat module lets you adjust each zone from your phone, and zoned savings come from heating or cooling only the rooms you are using, which keeps the system energy-efficient.

Frequently Asked Questions
What does a ducted air conditioning installation in Melbourne involve?
The job moves through a site assessment, heat load calculation, technology comparison and itemised quote. Once you accept, the crew installs the indoor unit, ductwork, vents, an outdoor unit where needed and the thermostat, then commissions the system to the manufacturer’s installation guidelines, registers the warranty, issues a compliance certificate and hands over a post-installation commissioning report.
Is ducted better than installing several split systems?
If you are comparing ducted against multiple split systems, ducted air conditioning in Melbourne gives whole-home coverage from one hidden system with only vents visible, while splits mean a wall unit and an outdoor unit for each room. A ducted system installation in Melbourne is the better fit for homes wanting central control, and splits suit homes needing room-by-room coverage in just one or two spaces.
Should my ducted cooling installation in Melbourne be refrigerated or evaporative?
Refrigerated cooling works in any humidity and can also heat if you choose reverse cycle. Evaporative cooling costs less to run and brings in fresh outdoor air, but loses performance on sticky days. Every ducted cooling installation in Melbourne we quote includes a running cost comparison for both.
Can one system provide ducted heating and cooling in Melbourne?
Yes. A reverse cycle ducted system heats in winter and cools in summer from one indoor and outdoor unit pairing, switching modes at the thermostat. It is the most common dual-function choice for households that would rather not run a separate gas heater and cooler.
How do I choose a ducted air conditioning installer in Melbourne?
Good installer selection starts with checking that the installer holds an ARCtick refrigerant licence and meets Victorian gas fitting requirements if gas heating is quoted. Ask for an itemised quote, confirm warranty registration is included, and make sure a commissioning report and compliance certificate are handed over at the end.
Which homes suit a ducted heating and cooling installation in Melbourne?
New-build homes with no existing system, including volume-builder jobs, display homes and project home packages, suit ducted, as do established homes with a roof cavity suited to ducting, two-storey homes that need zoning and renovated homes with extensions. Apartments and townhouses need a feasibility check first because external unit space is often limited and owners corporation approval may apply.
What affects the cost of a duct air conditioner installation in Melbourne?
Price depends on home size, the number of zones, the technology chosen and the equipment brand. We supply an itemised written quote after the site assessment, so you can compare installers on equal terms.
How long does a ducted installation in Melbourne take?
Most single-storey homes need one to two days for ductwork and unit installation, plus a commissioning visit. Two-storey homes, extra zones and renovation installation work, such as an extension needing additional ducting, can take longer, and the timeline is written into your quote.
Can I replace my ducted unit and keep the existing ductwork?
Yes, if the ductwork is in good condition and sized for the new unit’s airflow. The site assessment checks this first, and a replacement installation onto sound ducting saves the cost and mess of re-ducting. Heritage properties sometimes need local council approval through a planning permit, where applicable, and we confirm that before work starts.
Areas we serve
Serving Melbourne & Surrounding Areas
Brighton
Hampton
Broadmeadows
Hawthorn
Camberwell
Balwyn
Bundoora
Box Hill
Blackburn
Burwood
Mont Albert
Surrey Hills
Wollert
Fitzroy
Richmond
Epping
St Kilda
Prahran
Canterbury
Mt Waverley
Kensington
Parkville
Brunswick
Princes Hill
Flemington
Ascot Vale
Moonee Ponds
Ivanhoe
Heidelberg
Campbellfield
Bulleen
Templestowe
Craigieburn




